This wreath was so fun to create. I love making wreaths I must admit. To begin with I started with a bound straw wreath 18", and the bare slated wood 12 x 12". From the time I saw this wood piece at the craft store I've wanted to make a flag with it. When I started to brainstorm of how I could accomplish this, my mind went straight to May Arts EM net ribbon, and the light went on... Mod Podge. Yes, I also love Mod Podge. If you haven't used it before, roll up your sleeves and give it a shot. It's easy, and I promise you'll become addicted.
First things first! In addition to the wreath and wood, you will also need.....Floral Ivy (6 to 8 feet long)
Hot glue and gun
Craft Paint ( I used maple syrup color)
Spray Paint (hunter green)
Navy Blue Material 6 x 10"
Letter, Number stickers
And Ribbon of course, a lot of beautiful ribbon!
AX 30 Gold Stars 5 yards
C 503 Sheer Navy/Gold Stars
EM 14 Rd net 4 yards
EM 01 White net 4 yards
SP 03 Navy Burlap
SP 14 Red Burlap
E-Z Bow maker (if you have one)
I typically spray my wreath what ever color of floral I'm using.
You will want to pin the Ivy only to the front and sides of the wreath. This will make it lay flat against your door.
You also don't need to go into the center too much since the flag will cover this part.
Randomly lay your ivy on the wreath and push the floral pin into the straw to tack it down. Piece of cake!
Now you will randomly weave your gold stars among the Ivy and pin with the floral pins.
Your wood should be dry at this point, now sand your edges to take away some of the paint to give it a little bit of the stressed look. Not needed if you prefer not to.
Next get your paint brush and mod podge.
Also put mod podge in the center of the material to glue your stars. I then put a book on top of the stars only, just to give it enough weight to make sure the stars stay pressed down to dry.
I found on line you can purchase them from www.mainewreathco.com . It makes big bows a snap to make. (They did not pay me for that little advertisement.)
The bottom two layers are the white net and sheer blue stars ribbons combined in a 8" across (each loop is 4") and 6" across bow, 3 loops each side on both layers.
I then added 3 strips of gold stars for the middle.
The top bow is layered 4 times, starting with 5", 4 1/2", 4", and 3" bow layers 3 loops each side each layer
I then put them together with floral wire and wired it to the wreath.
At this point your flag should be fairly well dry.
Add the sticker letters and put a layer of mod podge over them to make them permanent.
Make your burlap bow with tails and hot glue to top corner of flag.
Once the letters are dry wire your flag to the wreath.
Weave your burlap tails through Ivy, and tack down with your floral pins.